271
Oty light
270 Oty light
Drill the ceiling with a cutter corresponding
to the diameter.
Bend the springs (2) of the housing (1) to put it into
the hole with a counterclockwise rotation.
Make the connection of the spot light to the remote gear.
Inserting element (3) inside element (1), pay
attention to fit the two little guide cylinders (5) of
the housing (1) into the grooves (4) (Stage A).
Rotate element (3) as far as it goes (Stage B).
Finally pull down element (3) till the foreseen final
position (Stage C).
To replace the LED light bulb, unscrew the two
screws (6). Gently remove the LED support (1).
After having replaced the LED lightbulb (7) put again
support (1) and screw again the two screws (6).
Drill the ceiling with a cutter corresponding
to the diameter.
Bend contemporarily the springs (2) of the housing (1)
to put it into the hole.
Unscrew the screw (4) of the lamp body.
Using the screw (4), fix the lamp body (3) to
the safety anti-fall cable (5).
Make the connection of the spot light to the remote gear.
Put the body of the lamp (3) into element (1) with
the CLICK UP.
Adjust element (6) as required.
To replace the LED light bulb, gently
remove the body of the lamp (3) DOWN.
Easy Pop i nstallation on plasterboad: Pop P00/P01/P02
Easy Pop i nstallation on plasterboad: Pop P03/PX3/PY3/PZ3
