Planning notes for the installation of ovens and oven combinations 400 and 200 series
General notes
Necessary air cross section
at the door edges
Installation behind kitchen
furniture doors
Appliance in operation only with open
doors. Appropriate measures must be
taken to prevent these types of doors
from closing when the appliance is
heating or while it is cooling down
(fan operation).
Installation side by side
When appliances are installed side by
side, the clearance between the
appliances must be at least 10 mm
(corresponds to the standard outside
measurement of the furniture cavity
of 600 or 762 mm).
The door hinges need to be placed
outside in order to use the full
available door opening angle.
Combination of ovens and
Vario cooling 400 series appliances
Please check the planning notes in
the information for Vario cooling
400 series appliances in order to
prevent the refrigerator door from
colliding with the oven.
Gaggenau ovens are cooled with
fresh air at the top edge and side
edges of the door. Hot air is blown out
at the door bottom edge. Combi-steam
ovens and Combi-microwave ovens
have the air inlet at the side edges of
the door and the hot air and steam
outlets at the top edge of the door.
In order to prevent appliances from
overheating and to ensure that they
cool down as required after operation,
appropriate minimum cross sections
of free space must be maintained
from kitchen furniture edges.
The measurements given in the
drawing apply to all appliances.
The following must also be observed:
The area above the appliances
BS:
No other electrical appliances should
be installed above the BS.
It is recommended that a horizontal
handle is not fitted on furniture above
the BS.
Where the edge of a kitchen unit
protrudes more than 20 mm from the
front edge of the furniture cavity, the
edge of the kitchen furniture panel
must be steam resistant as is the case
above a dishwasher. Steam may
possibly penetrate into the
compartment.
The area below the appliances
DV / WS:
It must be ensured that there is
sufficient access to the lower edge of
the vacuuming drawer and warming
drawer, if the thickness of the kitchen
furniture door is greater than 20 mm
in front of the furniture cavity.
All measurements in mm.
BO, BX, BS,
BM, CM, WS, DV
Ovens 400 series
14
