Additional planning notes for Vario cooling and cooling appliances 200 series
Door panels
Maximum permissible door panel weight
If the maximum permissible weight is exceeded, this may damage or impair the
function of the hinge.
Base area
Recess height
Number of
doors
Max. permissible
door panel weight
178 cm, Vario 200, 200 series
1
22 kg
178 cm, Vario 200, 200 series
2
19 kg each
178 cm, Vario 200, 200 series + RA 260 000
1
27 kg
178 cm, Vario 200, 200 series + RA 260 000
2
24 kg each
82 cm, 200 series
1
12 kg
178 cm, 123 cm, 200 series wine
1
20 kg
82 cm, 200 series RC/RT/RF
1
12/12/19 kg
Important!
Poor ventilation leads to damage of the appliance!
The appliance air inlet opening in the base area of the fitted kitchen must not be
covered under any circumstances.
A cross-section of at least 200 cm² must be provided for the air inlet opening.
Location
The appliance should be installed in a dry, well ventilated room. The location of the
appliance should not be subject to direct sunlight or near a source of heat, such as
an oven, a cooker or a radiator, etc.
If installation next to a heat source is unavoidable, observe the following minimum
distances from the heat source:
— 3 cm to electric or gas ovens,
— 3 cm to electric or gas cooker,
— 30 cm to an oil-fired or solid-fuel cooker.
Side-by-side installation
Vario 200 and 200 series cooling appliances can be installed side-by-side in the
following combinations except RT/RC/RF202, in their own kitchen units:
RW + RW
RC + RF (no other appliance next to RC model)
RW + RF (no other appliance next to RW model, except RW)
For all other combinations, a minimum clearance of 160 mm must be observed
between appliances.
Clearance to adjacent furniture depending on the furniture panel thickness
and radii
The panel thickness of customer-specific doors can be between 19 mm and 22 mm.
Recommended gap dimensions for flat hinges
All measurements in mm.
Dimensions of the special accessories – door panel frames
The following diagrams show the basic dimensions of the special accessories door
front frames for RW 282 and RW 222.
The dimensions of the doors shown are designed for the following basic specifications:
— Panel thickness: 19 mm
— Gap: 3 mm
These specifications provide you with a good starting point for a variety of
kitchen designs.
Important!
The following diagrams are not a substitute for detailed designs. Compliance
with specified requirements relating to kitchen design is essential.
Recess height 123 cm
Recess height 123 cm
Ventilation options
B:
A:
Air outlet ≥ 200 cm²; ventilation options B1 or B2
Air inlet ≥ 200 cm²; ventilation options A1 or A2
B1
B2
A1
(
A
)
A2
(
B
)
Cooling appliances
EB 333
Energy Label
Home Connect | Accessories
Ovens 400 series
Dish washers
Washing machine
Cooling appliances
Ovens 200 series
Ventilation appliances
Cooktops
Vario cooktops
349
