Integrated induction module
400 series
C U 421
C U 421 100
Integrated induction module ø 21 cm.
Knob needs to be ordered separately.
Necessary installation accessories
CK U 410 010
Stainless steel knob 400 series for
CU 421, CU 428.
Electronic control.
Set of 1 knob.
CK U 410 000
Black knob 400 series for
CU 421, CU 428.
Electronic control.
Set of 1 knob.
C A 420 000
Installation kit for integrated
induction.
One installation kit needed per
kitchen.
Necessary Special accessories
S P 410 000
Enhanced surface protector.
For pots and pans ø 10–14 cm.
For CU 421.
S P 415 000
Enhanced surface protector.
For pots and pans ø 15–18 cm.
For CU 421, CU 428.
S P 419 000
Enhanced surface protector.
For pots and pans ø 19–23 cm.
For CU 421, CU 428.
S P 400 000
Set of 4 enhanced surface protectors.
For pots and pans ø 10–28 cm.
For CU 421, CU 428.
Highlights
— Use of cookware directly on the
worktop, in combination with
12 mm Dekton worktops.
— Integrated 21 cm cooking zone with
booster function.
— Cooking zone center light, for
operation and residual heat
indication directly on the surface.
— Can be combined perfectly with
other integrated induction modules
of the 400 series.
— Solid stainless steel control knob
with illuminated ring, also available
in black finishing.
Cooking zone
1 induction cooking zone ø 21 cm
(2000 W, with booster 2300 W)
Handling
Control knobs with illuminated ring,
cooking zone and output level
markings for precise control.
Electronic power control in 12 output
levels.
Cooking zone center light indication.
Features
Booster function.
Keep warm function.
Options menu.
Safety
Only operates with enhanced surface
protector.
Operation indicator.
Pot detection.
2-stage residual heat indication
directly on the surface and knob.
Safety shut-off.
Planning notes
The integrated induction module must
be installed under Dekton worktops in
12 mm thickness. Do not install other
appliances below, e.g. ovens,
refrigerators or dishwashers. The
bearing capacity and stability, must
be supported using suitable
substructures. Take into account the
appliance weight and additional loads.
A 10 mm hole needs to be planned in
the center of the cooking zone.
Markings to indicate the cooking zone
need to be planned. No other cut-outs
permitted in the same worktop piece.
The elaboration of the Dekton is done
by local fabricators; for a list of
recommended fabricators, please
contact your local representative.
For Dekton fabricators: Refer to
Specification sheet “Marking and
drilling protocol for Gaggenau
Induction” by Cosentino.
Minimum distances:
Cooking zone center to lateral edge
of worktop 350 mm.
Cooking zone center to front and rear
edge of worktop 400 mm.
Cooking zone center to next cooking
zone center 350 mm or 450 mm
depending on combination.
Minimum distances at the back wall
of the furniture and openings, refer to
dimensional drawings.
Operates with magnetic (induction)
iron pots and pans only. For an optimal
heat distribution, the use of sandwich
bottom cookware is recommended.
Appliance weight: approx. 4.5 kg.
Please read the installation details
regarding air ducting on page 212.
Connection
Total connected load 2.3 kW.
Connecting cable 1.5 m without plug.
Connecting cable 1 m for control
knob.
Cooktops
170
