33
LED VERSION:
Class A/A+/A++
Luminaire supplied
with integrated LED modules
that cannot be replaced
A++
A+
A
67
kg
5kN
50Nm
H2O STOP
Naboo
NABOO
EU Regulation 874/2012 - Illumination equipment energy classes
LED VERSION:
Class A/A+/A++
Luminaire supplied
with integrated LED modules
that cannot be replaced
.0 Inox
• Round luminaire for installation in-ground – recessed.
• Configuration: three sizes available. Die-cast aluminium
structure and heat sink, EN AB-47100 alloy (low copper
content). AISI 316L stainless steel outer frame. Glass
diffuser: transparent with silkscreen border.
• Double layer coating for high resistance to corrosion:
the aluminium components are painted with a double
coat using powders which are compliant with QUALICOAT
standards: a first layer of epoxy powder (with excellent
chemical and mechanical resistance) and a second
finishing layer of polyester powder (resistant to UV rays
and atmospheric agents). The entire painting process of the
aluminium fitting starts from components which have been
sandblasted in advance to make the surface more porous
and increase the adherence of the paint. Ares effects
alkaline and acid washing to clean the surfaces completely,
then rinses with demineralised water to remove any residue
particles, subsequently a chemical conversion treatment is
done to protect against rusting.
• Light Emission: Fully adjustable optic, different beams
• Protection rating: IP67
• In compliance with EN60598-1 standards
• Class of insulation: II
• Installation: the luminaire is equipped with a watertight
M12 screw-connector providing optimal insulation against
water ingress and quick connection to the power supply
unit (supplied with the luminaire as a remote IP67 Kit with
electronic power supply). The power supply unit is equipped
with a piece of cable of 400mm with screw connector
towards the luminaire and a piece of cable of 300mm to
be used for wiring. Outdoor use requires suitable flexible
cables. Installation requires a dedicated box to be ordered
separately. It is important to provide a >300mm gravel layer
or a drain system (for concrete surface) to ensure good
drainage and to avoid water stagnation.
• We recommend the use of a connection system with a
protection degree greater than or equal to the protection
degree of the luminaire.
• During the installation and the maintenance of the fixtures
it is important to be careful and avoid damages on the paint
coating.
Damages on the coating exposed to outdoor conditions or
water, could cause corrosion.
Chemical substances affect the anticorrosion covering
protection.
Recessed ground
fitting
Do not install in
hollow areas
Installation requires
a 30cm water drai-
nage layer (gravel)
Pre-wired with approx
250mm of cable
Protection against
impact
IK 10- 20,00 joule
Drive over
Protection against
water ingress
from the cable
Glass surface temperature
<70°C
Naboo 145 - Naboo 225
Static load: 2000Kg
walk over
Naboo 290
Static load: 3000Kg
walk over