83
67
LED VERSION:
Class A/A+/A++
Luminaire supplied
with integrated LED modules
that cannot be replaced
A++
A+
A
Cassiopea
CASSIOPEA
kg
5kN
50Nm
H2O STOP
EU Regulation 874/2012 - Illumination equipment energy classes
LED VERSION:
Class A/A+/A++
Luminaire supplied
with integrated LED modules
that cannot be replaced
.0 Inox
Installation requires a
30cm water drainage
layer (gravel)
Protection against
impact.
IK 09 - 10,00 joule
Static load: 2000Kg
walk over (round version)
Static load: 3000Kg
walk over (square version)
Drive over
Pre-wired with approx
250mm of cable
(RGB: pre-wired with
2x250mm cables)
Do not install in
hollow areas
Recessed ground
fitting
Protection against
water ingress
from the cable
(not for RGB versions)
Glass surface temperature
<70°C
• Square or round luminaire – for installation in-ground
where recessing depth are limited (up to 120mm) –
recessed.
• Configuration: die-cast aluminium structure, EN AB-47100
alloy (low copper content).AISI 316L stainless steel outer
frame. Glass diffuser: transparent with silkscreen border.
• Double layer coating for high resistance to corrosion:
the aluminium components are painted with a double
coat using powders which are compliant with QUALICOAT
standards: a first layer of epoxy powder (with excellent
chemical and mechanical resistance) and a second
finishing layer of polyester powder (resistant to UV rays
and atmospheric agents). The entire painting process of the
aluminium fitting starts from components which have been
sandblasted in advance to make the surface more porous
and increase the adherence of the paint. Ares effects
alkaline and acid washing to clean the surfaces completely,
then rinses with demineralised water to remove any residue
particles, subsequently a chemical conversion treatment is
done to protect against rusting.
• Protection rating: IP67
• In compliance with EN 60598-1 standards
• Class of insulation: I
• Installation: the luminaire is equipped with a piece of
cable with a 2-way connector for 3-conductor cables (H2O
STOP) for an easy-to-make connection. RGB version: the
luminaire is equipped with 2 pieces of cable, no H2O STOP
connector provided. Outdoor use requires suitable flexible
cables. Installation requires a dedicated box to be ordered
separately. It is important to provide a >300mm gravel layer
or a drain system (for concrete surfaces) to ensure good
drainage and to avoid water stagnation.
• We recommend the use of a connection system with a
protection degree greater than or equal to the protection
degree of the luminaire.
• During the installation and the maintenance of the fixtures
it is important to be careful and avoid damages on the paint
coating.
Damages on the coating exposed to outdoor conditions or
water, could cause corrosion.
Chemical substances affect the anticorrosion covering
protection.
