141
67
Idra
IDRA
kg
5kN
50Nm
H2O STOP
LED VERSION:
Class A/A+/A++
Luminaire supplied
with integrated LED modules
that cannot be replaced
A++
A+
A
METAL HALIDE VERSION:
Class A+
HIT-TC-CE/G8,5
A+
HALOGEN VERSION:
Class B
QR-CBC51/GU5,3
B
HALOGEN VERSION:
Class D
QT32/E27
D
HALOGEN VERSION:
Class D
QPAR51/GU10
D
EU Regulation 874/2012 - Illumination equipment energy classes
LED VERSION:
Class A/A+/A++
Luminaire supplied
with integrated LED modules
that cannot be replaced
Remote device
required
Installation requires a
40cm water drainage
layer (gravel)
Pre-wired with approx
250mm of cable
Protection against
impact.
IK 09 - 10,00 joule
Static load: 2000Kg
walk over
Drive over
Do not install in
hollow areas
Recessed ground
fitting
Protection against
water ingress
from the cable
Check that diffuser’s tempera-
ture “T max °C”(tested at 25°C)
complies with your local
regulation
Glass surface temperature
<70°C for LED source
.0 Inox
• Round luminaire for installation in-ground – recessed.
• Configuration: AISI 316 deep-drawn stainless steel
structure with milled AISI 316L stainless steel finish frame.
Glass diffuser: transparent or sandblasted. The stainless
steel structure allows installation in extreme conditions
(sea or road salt).
• Protection rating: IP67
• In compliance with EN 60598-1 standards
• Class of insulation: mains: I; low voltage: III
• Installation: the luminaire is equipped with a piece of cable
with a 2-way connector for 3-conductor cables (H2O STOP)
for an easy-to-make connection. LED 24V is equipped
with a dc/dc highly efficient converter that removes
electromagnetic interference and allows parallel wiring
and is protected against polarity reversal and sudden
voltage peak. Outdoor use requires suitable flexible cables.
Installation requires a dedicated box for installation (to be
ordered separately). It is important to provide a >400mm
gravel layer or a drain system (for concrete surface) to
ensure good drainage and to avoid water stagnation.
• We recommend the use of a connection system with a
protection degree greater than or equal to the protection
degree of the luminaire.
• During the installation and the maintenance of the fixtures
it is important to be careful and avoid damages on the paint
coating.
Damages on the coating exposed to outdoor conditions or
water, could cause corrosion.
Chemical substances affect the anticorrosion covering
protection.
METAL HALIDE VERSION:
Class A+
HIT-TC-CE/G8,5
HALOGEN VERSION:
Class D
QT32/E27
QPAR51/GU10
HALOGEN VERSION:
Class B
QR-CBC51/GU5,3
