103
67
LED VERSION:
Class A/A+/A++
Luminaire supplied
with integrated LED modules
that cannot be replaced
A++
A+
A
Rho
RHO
850°C
kg
H2O STOP
EU Regulation 874/2012 - Illumination equipment energy classes
LED VERSION:
Class A/A+/A++
Luminaire supplied
with integrated LED modules
that cannot be replaced
.0 Inox
• Round luminaire for installation on wall, ceiling or ground
– recessed.
• Configuration: turned aluminium body (EN AW-6060
alloy) with 15 micron anodizing for high resistance to
corrosion. AISI 316L cap, open frame and cover. Diffuser:
polycarbonate or methacrylate transparent or sandblasted
(see the catalogue pages for reference).
• Double layer coating for high resistance to corrosion:
the aluminium components are painted with a double
coat using powders which are compliant with QUALICOAT
standards: a first layer of epoxy powder (with excellent
chemical and mechanical resistance) and a second
finishing layer of polyester powder (resistant to UV rays
and atmospheric agents). The entire painting process of the
aluminium fitting starts from components which have been
sandblasted in advance to make the surface more porous
and increase the adherence of the paint. Ares effects
alkaline and acid washing to clean the surfaces completely,
then rinses with demineralised water to remove any residue
particles, subsequently a chemical conversion treatment is
done to protect against rusting.
• Protection rating: IP67
• In compliance with EN 60598-1 standards
• Class of insulation: III
• Installation: the luminaire is equipped with a piece of
cable for an easy-to-make connection. In-ground version:
the cable is integrated with an H20 STOP device. Rho
is equipped with a dc/dc highly efficient resin-coated
converter that removes electromagnetic interference and
is protected against polarity reversal and sudden voltage
peak. Outdoor use requires suitable flexible cables.
Installation in solid surfaces requires a dedicated box for
installation to be purchased separately, installation in
panels is only possible with the version with springs. It is
important to provide for the in-ground version a >200mm
gravel layer or a drain system (for concrete surfaces) to
ensure good drainage and to avoid water stagnation.
• Parallel wiring
• We recommend the use of a connection system with a
protection degree greater than or equal to the protection
degree of the luminaire.
• During the installation and the maintenance of the fixtures
it is important to be careful and avoid damages on the paint
coating.
Damages on the coating exposed to outdoor conditions or
water, could cause corrosion.
Chemical substances affect the anticorrosion covering
protection.
Protection against
impact.
IK 06 - 1,00 joule
(version with frame)
IK 08 - 5,00 joule
(version with cover)
Glow wire test: 850°C
Pre-wired with approx
200mm of cable
Remote device
required.
Installation requires a
20cm water drainage
layer (gravel).
Static load: 500Kg
walk over (version with frame)
Static load: 2000Kg
walk over (version with cover)
Recessed ceiling fitting
- In masonry: it is needed
the installation box
- In plasterboard wall:
version with springs
Recessed wall fitting
Do not install in
hollow areas
Recessed ground
fitting
Protection against
water ingress from the cable
(only for in-ground
recessed versions)
Glass surface temperature
<70°C
