18
19
Important Information
The Numbering System
The five-figure number refers to the model. This is followed
after a full stop by the product type (this number is omitted
in the case of hanging chandeliers). Then, after a hyphen,
either the number of bulbs or the diameter (cm) is indicated.
Example: 40600-8 = chandelier with 8 outer flames
Example: 77514-80 = chandelier with 80 cm diameter
and inner flames
Possible product types:
.2 = halogen fitted recess lamp
(transformer not included in delivery)
.4 = end table lamp (from 50 cm height)
.5 = wall bracket
.6 = floor lamp
.7 = flush-to-ceiling lamp with reflector
(direct ceiling attachment)
.8 = table lamp (up to 50 cm height)
.9 = mirror
Example: 40600.5-2 = wall bracket with 2 flames
Example: 28100.7-50 = flush-to-ceiling lamp with reflector
(A at the beginning of a model number refers to a
customised design)
Dimensions
All dimensions are indicated
in cm in the sequence
2 width 3 height.
With wall brackets and mirrors
1 depth is also added.
example: 2 28 3 35 1 16
The height refers to the height
without canopy and chain.
It is followed in brackets ( )
by the minimum suspension
height of a chandelier.
example: 2 93 3 140 (160)
Electrical installation
Our chandeliers conform to the international norms.
The cabling is suitable for 110 - 240 V.
Each chandelier is tested with 5000 V.
Depending on the product type, the following sockets
are integrated:
B15
Export UK
E26
Export US, JAP
B22
Export UK
E27
Standard
E12
Export US
G4
Standard
E14
Standard
G9
Standard
E17
Export JAP
GU10
Standard
Dimmers
We recommend the use of large-scale dimmers, with elec-
tronics that should be built into a switchboard panel if
possible. This enables bulbs of higher wattage to be used –
they may be adjusted to suit your requirements, and the
lower load also means that they last a lot longer. When
using LEDs, the dimmability must be checked. Dimmers
should be subjected to a load of no more than 80 %.
Recommended bulbs
Lamps are not included in the price of the chandelier, but
may certainly be included in the order. Depending on the
model, we recommend the following lamp types:
LED lamps
We offer LED variants for the above-mentioned sockets
(LED lamps have improved light efficiency, lower power
consumption, less heat development and longer service life).
You can fit any FAUSTIG crYSTAl chANDelIer with
suitable leD lamps.
In this regard, the following should be considered:
- the dimmability
- a pleasant colour temperature of approximately 2800 K
(warm white)
- adequate light efficiency of at least 220 lm.
For comparison:
220 - 250 lm = conventional 25-watt bulb
410 - 470 lm = 40-watt bulb
700 - 810 lm = 60-watt bulb
High-voltage halogen lamps:
E14 and E27 are also available as high-voltage halogen
lamps (improved light efficiency, lower power consump-
tion, less heat development, longer service life).
G9 with plug-in base
GU10 spot with bayonet mount
Low-voltage halogen lamps:
Low-voltage sockets need to be fitted with 12 V - 5-20 W
G4 lamps.
Lamp installation
The normal chain or cable length including canopy is
about 80 cm. Should you require a different length when
placing your order, no additional charge will be made.
Heavy fittings are also equipped with an extra
stainless steel safety cable.
Spare parts
Essential spare parts are delivered free of charge with
each fitting. Any additional spare parts required are
normally sent the same day. Do please send a sample,
though, even if it is in fragments.
Care and maintenance
Before cleaning, switch off the fuse!
A cRySTAL cHANDELIER can be quickly dusted down
using a soft brush or a feather duster. From time to time,
however, to preserve its brilliance and beauty, the crystal
should be cleaned with water, a brush, soft cloths and mild
detergent. This will ensure that your FAUSTIG cRySTAL
cHANDELIER brings you many years of enjoyment.
3
(3)
3
