STANDARD CABLE
KABLE LITE CUSTOM
The engineering behind Kable Lite invites creative customization. With tools for joining cables end-to-end with conductive
or isolating connectors, you can add additional lines while separating their power sources. Take full control of where the
light goes. Set the mood, complement the surroundings or just provide general illumination by making your own Kable Lite
system. Solve easy or complex lighting challenges of accent lighting or finally finding the lighting to match that one room
that never looks quite right.
TIPS:
• Cable is sold by the foot (0.3 m).
Order the length of your Kable Lite
run x 2 and add 10 percent to each.
700KLABAREC
700KLAINSCL
JOINING CABLE END TO END
BARE CABLE
Rated for 300 watts at 12 volts, 600 watts at 24 volts. Load: 300 watt maximum at 12 volts to 30' before voltage drop
occurs; 600 watt maximum at 24 volts to 60' before voltage drop occurs. #10 gauge tin-plated copper cable.
INSULATED CABLE
Use insulated cable where required by local codes or in coastal areas, where salty air might oxidize bare cables.
#10 gauge tin-plated copper cable; sheathed in clear insulation.
CONDUCTIVE CONNECTORS
Connectors join cables end to end. Sold in pairs.
Satin Nickel.
700PARTD2S
ISOLATING CONNECTORS
Plastic connectors join cables end to end and isolate
power feeds from each other. All dual-feed canopies
and dual-feed surface transformers are shipped with
isolating connectors; order additional if required by
layout. Sold in pairs.
700PARTD1 (FOR USE WITH BARE CABLE)
700PRTD1L (FOR USE WITH INSULATED CABLE)
