6
Protection class
IP65
Mechanical resistance
IK 10
Leds 4000K CRI80 versions are
available on request.
24V DC versions available with
surcharge for use with remote
dimmable drivers not included.
PATENT PENDING
REGISTERED DESIGN
For the latest technical information
and luminaire updates with LED
technology please refer to
www.simes.it
Luminaire guide video
Ghost for Cladding
Ghost for cladding can be installed in
plasterboard panels for indoors, exterior
fiber cement siding panels, breeze blocks
or other construction materials that
require a surface finish. A fixture that has
been developed to be totally integrated
into the architecture. The slanted front
aperture can either be in anodised
aluminium or it can be finished with
the same material finish as the wall. The
front lip of the recessed housing and the
aluminium sides of the front aperture will
remain visible.
Procedure for Plasterboard or exterior
fiber cement siding panels
1. Position the conduit for the electrical
feed.
2. Fix the product to the plasterboard
panel.
3. Cover the gaps between the panels
with a mesh and plaster over.
4. Complete the surface finish
5. The fixture is supplied with a slanted
front panel accessory in anodised
aluminium. For indoor applications this
panel can be removed and then finished
in plasterboard; for outdoor applications
we suggest to use this panel (a 19mm
recess depth has been provided for the
final finish if the panel is not used).
6. Once the plaster is dry you can fit the
LED profile into the void.
This is the procedure for other walls built
on site:
1. Cut away and position the conduit for
the electrical feed;
2.Create a niche and recess the fixture
housing and align correctly;
3. Cement the housing into the niche
and use a gripping mesh to cover both
the wall and the housing;
4. Cement the fixtue into the wall, cut
the gripping mesh around the fixtures
aperture and continue with the finish
by applying the relative material to the
slanted aperture (19mm recess depth
has been provided for the final finish if
the panel is not used).
5.The fixture is supplied with an
anodised aluminium front panel. You
can decide to use this panel so to have a
complete aperture in anodised aluminium
or without so to render the aperture in
the same material finish as the rest of
the surface.
6. Once the cladding is dry you can fit
the LED profile into the void.
MICROGHOST SQUARE
Requires a remote constant voltage
driver.
Pre-wired luminaire with 6m of neoprene
cable.
CLASS III
GHOST LINEAR
Luminaire supplied with 6m of cable.
CLASS II q
NOTE The aluminium front panel
can eventually be painted (care of
the installer) but never covered with
other materials as this will obstruct the
installation or removal of the lighting
element.
