331
Flush-fit installation
Surface-mounted installation
Flush-fit installation
1) Cut-out for vent ducting in unit floor
2) Ensure that the worktop is sufficiently stable
3) Stepped cut-out for flush-fit installation in a worktop. Note the different milling widths for the
hob and the downdraft extractor. Instead of a stepped cut-out, a wooden frame (not supplied)
that has been moved downwards by 5.5 mm can be installed as an alternative. Exhaust duct,
diameter 150 mm.
1) Cut-out for vent ducting in unit floor.
2) Ensure that the worktop is sufficiently stable.
1) Cut-out for vent ducting in unit floor
2) Ensure that the worktop is sufficiently stable.
3) Stepped cut-out for flush-fit installation in a worktop. Note the different milling widths for the
hob and the downdraft extractor. Instead of a stepped cut-out, a wooden frame (not supplied)
that has been moved downwards by 5.5 mm can be installed as an alternative. Exhaust duct,
diameter 150 mm.
It is possible to install the KM and DAD in a shared cut-out. The downdraft extractor must be delivered or retrofitted with the requisite accessories (DWL 80) for this purpose. Information on this
subject is available separately. The following dimensions apply in this installation scenario:
22-1557_Part20_Skizzen_VitroLine_Gen7000_Kurz_GB.indd 331
22-1557_Part20_Skizzen_VitroLine_Gen7000_Kurz_GB.indd 331
16.03.23 14:01
16.03.23 14:01
