363
Linear System
2000 Lm
Fylo+
Fylo+ Surface
Fylo+ Recessed
Quick installation
The profiles are snap-coupled on a
dedicated bracket. Special plastic elements
were introduced into the rear of the profiles,
in the linear guides where they slide. Fixing
is not bound to a pre-established point and
so it can be installed as the installation
technician wishes.
Fylo+ Recessed is provided for cardboard wall-mounted
installation. For installation on existing walls is sufficient
to remove the lateral flaps included in the profile.
Installation process
Fylo+ keeps the aesthetics intact as
compared to the previous versions. Once
installed, the profiles are concealed
fully camouflaging with the surrounding
architecture; the integrated light concept
allows to customise the spaces with
unique and precious light details.
More light, more efficiency
The choice of aluminium, lightened due
to the specific design developed for
the profiles section, allows to exploit
the surface of the module as a diffuser
enhancing the light performance
available for the range of products.
Continuous line
The new ROLL DIFFUSER was designed to
create continuous light lines. Once coupled
at the ends, the special polycarbonate reel
unwinds following the profile along its entire
length: this solution allows avoiding complex
installation operations, replaced by a single,
simple assembly operations with drastically
reduced times. With the equipment lit, the
diffuser screens and harmonises the light
emitted by the source, reducing glaring
drastically even when observed directly.
Bring the profile
closer to the bracket
Push the product firmly
against the bracke
Aluminium
Quartz powder resin.
Pre-treated
aluminum profile.
Mixed building material
resin applied with
several coats granting a
homogeneous and thick
surface, ready to be sanded
and serving as a support
for the final coat of paint.
Final paint.
Application of
primer as if it was
on plasterboard.
