327
cautions
INFORMATION WITH REGARDS TO THE
CORRECT INSTALLATION / FUNCTIONING
OF ILTI LUCE LED LUMINAIRES
Installation and electrical connection must be
����������������������������������
Never switch on LED luminaires without the power
supply being connected.
������������������������������������������������������
on the mounting instructions.
�������������������������������������������������
with regards to the minimum/maximum number of
luminaires which can be connected.
Always check if the IP rating of the luminaires is
suitable for the desired application.
Unless otherwise stated, the luminaires are neither
walk over nor drive-over.
���� �������� ���� ��������� ��� ������������ ���
temperature which can result in undesired colour
��������������������������������������������������
dissipation of heat always make sure that the
area/room where the luminaire will be installed
are adequately ventilated. Never cover the metal
������������������������������������������������������
��������������������������������������������������������
INFORMATION WITH REGARDS TO IP65
AND IP68 LUMINAIRES FOR OUTDOOR
������������������������������������������������
never be opened.
In case of recessed luminaires for exterior use,
always prepare a drainage layer under the recessed
�������������������������������������������������������
the use of the listed ILTI LUCE recessed boxes.
��������������������������������������������������
substances deposited on surfaces in contact with
air and water.
For use in thermal waters, in waters with chemical
��������������������������������������������������
�������������������������������������������������������
staff for advise concerning the use of luminaires in
such applications.
MAINTAINENCE
Before cleaning the luminar, switch off the power
supply and let it cool down.
It is essential to clean the luminair periodically
at regular intervals in order to remove the
dust, dirt, limestone or other contaminations.
Not maintaining the luminaires may result in
malfunctioning.
Clean the luminaires using a soft cloth damped
in lukewarm water.
Do not use cleaning products which contain acidic
substances. Do not use cleaner machines.
Luminaires must not be used in corrosive
environments, exposure to corrosive substances
must be avoided at all times. In case of doubts
concerning chemical resistancy of our luminaires
please contact our technical department.
WARRANTY
The producer does not accept any liability for
damage of the luminaires, property or persons,
caused by the use of a wrong driver or by faulty
electrical connection.
The warranty does not cover defects and/or
damages caused by wrong use in cases where the
installation instructions have not been followed.
The producer does not accept any liability for
defects caused by natural disaster or by vandalism.
LED WARNINGS
The LEDs used by ILTI LUCE are selected in order
to provide the best uniformity in terms of chromatic
���������� ���� ������ ����������� �������� ������
precautions, there may be differences within a
��������������������������������
Technical notes and wiring diagrams are to be
considered purely indicative and are not binding.
���������������������������������������������������
of ILTI LUCE.
Dimensions of the power supplies stated in the
present catalogue are purely indicative and they are
subject to change without notice.
Due to quick technological improvements in LED
technology related to lm/w ratios ILTI LUCE reserves
������������������������������������������������������
As a consequence, the photometric data are to
be considered purely indicative and subject to
continuous improvements.
GENERAL WARNINGS
The present catalogue replaces the previous version,
the previous version is no longer considered valid.
Products shown in this catalogue are conform the
RAEE (WEEE) Directive Legislative Decree n. 151
version 31 December 2006, including RoHs directive.
Products are conform EN60598(2004/108/CE,
2006/96/CE and version 93/68), built and tested in
accordance with the latest regulations.
ILTI LUCE reserves the right to eliminate products
from the program as offered in this catalogue without
prior consent. The program in this catalogues can
be altered without prior consent due to the technical
development of the LEDs.
��� ���� ������������ ���������� ������ ����������
accessories and other parts not listed as being
included are believed to be excluded.
ILTI LUCE cannot be held responsible for
malfunctioning, short lifespan and decrease in light
output if the products are not driven and connected
�������������������������
Photography, images and product descriptions in
this catalogue are intended to present the product
and cannot considered binding.
������������������������������������������
�����������������������������������������������������
suited for pedestrian areas.
The dimensions of the LED drivers are indicative.
�������������������������������������������
All products, power supplies and accessories
installed must be accessible and available for
inspection to ensure proper maintenance.