360
cautions
Information with regards to the correct installation/
functioning of ilti luce led luminaires.
Installation and electrical connection must be per-
formed by a qualified installer.
Never switch on LED luminaires without the power
supply being connected.
Never open the luminaire, if not specifically indica-
ted on the mounting instructions.
Always check the specification of the power sup-
ply with regards to the minimum/maximum number of
luminaires which can be connected.
Always check if the IP rating of the luminaires is
suitable for the desider application.
Unless otherwise stated, the luminaires are neither
walk over nor drive-over.
LED fittings are affected by fluctuations in tem-
perature which can result in undesired colour shift or
loss of luminous flux. To ensure adequate dissipation
of heat always make sure that the area/room where
the luminaire will be installed are adequately ventilated.
Never cover the metal dissipater of a luminair as this
restricts the flow of air and will result in a shorter than
specified lifetime.
Information with regards to ip65 and ip68 luminaires
LED fittings rated IP65,IP66,IP67 or IP68 should
never be opened.
In case of recessed luminaires for exterior use,
always prepare a drainage layer under the recessed
box. The correct installation in the floor is only with the
use of the listed ILTI LUCE recessed boxes.
Periodically clean the fittings to remove dirt and
substances deposited on surfaces in contact with air
and water.
For use in thermal waters, in waters with chemical
additives, we always suggest to use TF fixtures in syn-
thetic material and/or refer to the technical office staff
for advise concerning the use of luminaires in such ap-
plications.
Maintainence
Before cleaning the luminar, switch off the power
supply and let it cool down.
It is essential to clean the luminair periodi-
cally at regular intervals in order to remove the
dust,dirt,limestone or other contaminations. Not main-
taining the luminaires may result in malfunctioning.
Clean the luminaires using a soft cloth damped in luke-
warm water.
Do not use cleaning products which contain acidic
substances. Do not use cleaner machines.
Luminaires must not be used in corrosive envi-
ronments, exposure to corrosive substances must be
avoided at all times. In case of doubts concerning che-
mical resistancy of our luminaires please contact our
technical department.
Warranty
The producer does not accept any liability for da-
mage of the luminaires, property or persons, caused
by the use of a wrong driver or by faulty electrical con-
nection.
The warranty does not cover defects and/or da-
mages caused by wrong use in cases where the instal-
lation instructions have not been followed.
The producer does not accept any liability for de-
fects caused by natural disaster.
Led warnings
The LEDs used by ILTI LUCE are selected in order
to provide the best uniformity in terms of chromatic ef-
ficiency and light efficiency. Despite these precautions,
there may be differences within a tolerance approxima-
tely +/- 10%.
Technical notes and wiring diagrams are to be consi-
dered purely indicative and are not binding. For informa-
tion please contact the Technical Office of ILTI LUCE.
Dimensions of the power supplies stated in the
present catalogue are purely indicative and they are
subject to change without notice.
Due to quick technological improvements in LED
technology related to lm/w ratios ILTI LUCE reserves
the rights to alter the specifications of our products.
As a consequence, the photometric data are to be
considered purely indicative and subject to continuous
improvements.
General warnings
The present catalogue replaces the previous ver-
sion, the previous version is no longer considered valid.
Products shown in this catalogue are conform the
RAEE (WEEE) Directive Legislative Decree n. 151 ver-
sion 31 December 2006, including RoHs directive.
Products
are
conform
EN60598(2004/108/CE,
2006/96/CE and version 93/68), built and tested in
accordance with the latest regulations.
ILTI LUCE reserves the right to eliminate products
from the program as offered in this catalogue without
prior consent. The program in this catalogues can be
altered without prior consent due to the technical de-
velopment of the LEDs.
If not specifically specified ,power supplies, acces-
sories and other parts not listed as being included are
believed to be excluded.
ILTI LUCE cannot be held responsible for malfun-
ctioning, short lifespan and decrease in light output if
the products are not driven and connected to a speci-
fied LED driver.
Photography, images and product descriptions in
this catalogue are intended to present the product and
cannot considered binding.
Photometric files are available on request.
I not specifically indicated, the Luminaires are not
suited for pedestrian areas.
The dimensions of the LED drivers are indicative
All dimensions are specified in millimeters.
All products, power supplies and accessories in-
stalled must be accessible and available for inspection
to ensure proper maintenance.
