Vario electric grill 400 series
V R 414
V R 414 115
Stainless steel.
Width 38 cm.
Knobs need to be ordered separately.
Included in the price
1 cast pan, half size.
2 cast grills.
1 lava stone.
1 cleaning brush.
Necessary Installation accessories
CKR 420 010
Stainless steel knobs 400 series
for VR 414.
Electronic control.
Set of 2 knobs.
CKR 420 000
Black knobs 400 series for VR 414.
Electronic control.
Set of 2 knobs.
Installation accessories
V A 420 004
Connection strip for combination with
other Vario appliances of the
400 series for flush mounting.
V A 420 010
Connection strip for combination with
other Vario appliances of the
400 series for surface mounting.
V A 440 010
Stainless steel appliance cover with
mounting strip.
Special accessories
L V 030 000
Lava stone for refilling.
Highlights
— Two zones can be operated
together or separately.
— Cast pan, half size,
for simultaneous frying and grilling
on two separate surfaces.
— Open cast grill, lava stone.
— Solid stainless steel knob, also
selectable with black robust
finishing, for precise control and
personalisation.
— Precision crafted 3 mm stainless steel.
— For surface mounting with a visible
edge or for flush mounting.
— Can be combined perfectly with
other Vario appliances of the
400 series.
Handling
Control knobs with illuminated ring,
cooking zone and output level
markings.
Electronic control in 12 output levels.
Features
Cooktop, lava stone trough and
grease collecting insert from stainless
steel.
Two zones, each 1500 W, can be
operated together as a complete
surface or each half separately.
Two-part cast grill.
Safety
Safety shut-off.
Pre-heat and residual heat indicator.
Planning notes
Depending on the type of installation
(surface-mounted or flush-mounted,
with or without an appliance cover),
the specific location of the cut-out
and the knob positions may vary.
If installing with the appliance cover
VA 440 take into account the
additional space required for the
depth.
If combining several Vario appliances
of the 400 series, select combinations
with or without appliance cover, and a
connection strip VA 420 must be
placed between the appliances.
Depending on the type of installation,
the corresponding connection strip
must be provided.
The bearing capacity and stability, in
the case of thinner worktops in
particular, must be supported using
suitable substructures. Take into
account the appliance weight and
additional loads.
Additional instructions for flush
mounting:
Installation is possible in worktops
made of stone, synthetics or solid
wood. Heat resistance and watertight
sealing of the cut edges must be
observed. Concerning other materials
please consult the worktop
manufacturer.
The groove must be continuous and
even, so that uniform placing of the
appliance on the gasket is ensured.
Do not use discontinuous lining.
The joint width may vary due to size
tolerances of the combinations and of
the worktop cut-out.
Please read additional planning notes
on page 132–136.
If installing several appliances in
individual cut-outs allow for a division
bar of minimum 50 mm between the
individual cut-outs.
A minimum lateral clearance of at
least 100 mm from adjacent
heat-sensitive furniture or from the
wall must be observed.
Appliance can be snapped into the
worktop from above.
Appliance weight: approx. 26 kg.
Connection
Total connected load 3.0 kW.
Connecting cable 1.5 m without plug.
Connecting cables 0.3 m and 1 m for
control knobs.
Vario cooktops
128
