Base area | Crown of the niche
Crown
The height of the cabinet door on the appliance is dependent on:
–
the overall height of the appliance,
–
the distance from the bottom edge of the cabinet door to the floor,
–
the appliance type (one-door or multi-door appliances).
The overall height of the appliance is 2.029 mm.
The height can be adjusted within a range of -13 mm to +35 mm. You must observe
the minimum distance of 100 mm between the upper edge of the floor and the
bot tom edge of the cabinet door of the appliance.
This height can vary depending on the conditions at the site. It is possible, e.g. for
design reasons, to lengthen the cabinet door upwards by extending it beyond the
top of the appliance.
Important!
It must be ensured that the crown of the instal lation niche always has a depth of
at least 100 mm (measured from the front edge of the appliance). Only then can
the secure installation of the appliance in the installation niche be guaranteed.
Extending the
cabinet door
Appliance
door
Crown
Appliance body
Cabinet door on
the appliance
Base area
Important!
Poor ventilation leads to damage to the appliance!
Under no circumstances is it permitted to cover the air inlets and the exhaust air
outlets of the appli ance in the lower base area. You must observe the minimum
distance of 100 mm between the upper edge of the floor and the bot tom edge of
the cabinet door of the appliance. Take this into consideration also when
adjusting the appliance feet.
In relation to the standard height, the maximum height of the base board is 102 mm.
The plinth can be maximum 19 mm thick.
Adhesive connectors are supplied on the front panel of the appliance for fitting the
base board.
The air inlets and the exhaust air outlets of the appliance are located above the base
board. They must not be covered.
For design reasons, it may be necessary to in crease the distance between the upper
edge of the floor and the bottom edge of the cabinet door of the appliance, so that it
extends beyond the stan dard dimension of 102 mm.
The maximum dimen sion is 181 mm. If this is the case, air inlets and exhaust air
outlets would become visi ble!
