1
:
Direct installation
2
:
Installation with extension for extra deep worktop and plastic ducting:
– AD 851 041 (Connecting piece for extension)
– AD 857 040 (Flat duct connecting piece, plastic)
– AD 857 030 (Flat duct bend 90° vertical, plastic)
3
:
Installation with extension for extra deep worktop and metal ducting:
– AD 851 041 (Connecting piece for extension)
– AD 854 000 (Flat duct connecting piece, metal)
– AD 854 030 (Flat duct bend 90° vertical, metal)
A
:
≥ 50mm
B
:
Connecting piece
measurements in mm
(
B
)
(
B
)
(
B
)
(
A
)
(
1
)
(
2
)
(
3
)
500+
A
600+
A
(
A
)
635+
A
735+
A
(
A
)
640+
A
740+
A
Good to know – for correct planning and installation
– For depth measurements, take account of the depth of the furniture cavity and worktop overhangs of the kitchen furniture.
– It is also important that ducting is well sealed in order to prevent air leaks, e.g. by using the adequate adhesive tape or using the adequate connecting piece.
– Vario cooktops like Vario electric grill or Vario gas wok should be placed between 2 VL.
– In case of Vario electric grill air recirculation is not recommended.
– With the Vario downdraft ventilation, the ducting can be connected straight down (1) or to the rear using additional connecting pieces (2) and (3). These are available as
special accessories, see below.
For the total overall dimensions in the furniture, please also take into account the individual dimensions and position of the ducts and the remote fan unit.
The remote fan unit can be turned in all directions, depending on the desired direction for the exhaust air or filter removal.
