V R 414 111
Stainless steel
Width 38 cm
Included in the price
1 cast pan, half size
1 grease collecting insert
2 cast grills
1 lava stone
1 cleaning brush
Installation accessories
V A 420 004
Connection strip for combination with
other Vario appliances of the
400 series for flush mounting
V A 420 010
Connection strip for combination with
other Vario appliances of the
400 series for surface mounting
V A 440 010
Stainless steel appliance cover with
mounting strip
Special accessories
L V 030 000
Lava stone for refilling
V A 461 000
Cast pan, enamelled, half size
For Vario electric grill 400 series.
For simultaneous frying and grilling on
two separate surfaces.
Combinable with:
Ceiling ventilation 400 series
Ceiling ventilation AC 250
Table ventilation 400 series
Island- and wall-mounted hood 400 series
Downdraft ventilation 400 series
Flat kitchen hood 200 series
Canopy extractor 200 series
Good to know:
the hood has to be larger than the
cooktop(s) or it has to be as large as
the cooktop(s). Please check the
requirements in chapter ventilation.
Vario electric grill 400 series
V R 414
–
Two zones can be operated
together or separately
–
Cast pan, half size, for simultane-
ous frying and grilling on two
separate surfaces
–
Open cast grill, lava stone
–
Solid stainless steel control knob
–
Precision crafted 3 mm stainless
steel
–
For surface mounting with a visible
edge or for flush mounting
–
Can be combined perfectly with
other Vario appliances of the
400 series
Handling
Control knobs with illuminated ring,
cooking zone and output level markings.
Electronic control in 12 output levels.
Features
Cooktop, lava stone trough and grease
collecting insert from stainless steel.
Two zones, each 1500 W, can be
operated together as a complete
surface or each halve separately.
Two-part cast grill.
Safety
Safety shut-off.
Pre-heat and residual heat indicator.
Planning notes
Depending on the type of installation
(surface-mounted or flush-mounted,
with or without an appliance cover), the
specific location of the cut-out and the
knob positions may vary.
If installing with the appliance cover
VA 440 take into account the additional
space required for the depth.
If combining several Vario appliances
of the 400 series, a connection strip
VA 420 must be placed between the
appliances. Depending on the type of
installation, the corresponding
connection strip must be provided.
The bearing capacity and stability, in
the case of thin worktops in particular,
must be supported using suitable
substructures. Take into account the
appliance weight and additional loads.
Additional instructions for flush mounting:
Installation is possible in worktops
made of stone, synthetics or solid wood.
Heat resistance and watertight sealing
of the cut edges must be observed.
Concerning other materials please
consult the worktop manufacturer.
The groove must be continuous and
even, so that uniform placing of the
appliance on the gasket is ensured.
Do not use discontinuous lining.
The joint width may vary due to size
tolerances of the combinations and of
the worktop cut-out.
Please read additional planning notes
on page 132 – 136.
If installing several appliances in
individual cut-outs allow for a division
bar of minimum 50 mm between the
individual cut-outs.
A minimum lateral clearance of at least
100 mm from adjacent heat-sensitive
furniture or from the wall must be
observed.
Appliance can be snapped into the
worktop from above.
Appliance weight: approx. 26 kg.
Connection
Total connected load 3.0 kW.
Connecting cable 1.5 m without plug.
