V P 414 111
Stainless steel
Width 38 cm
Included in the price
2 spatula
Installation accessories
V A 420 004
Connection strip for combination with
other Vario appliances of the
400 series for flush mounting
V A 420 010
Connection strip for combination with
other Vario appliances of the
400 series for surface mounting
V A 440 010
Stainless steel appliance cover with
mounting strip
Combinable with:
Ceiling ventilation 400 and 200 series
Table ventilation 400 series
Island- and wall-mounted hood 400 series
Downdraft ventilation 400 series
Flat kitchen hood 200 series
Canopy extractor 200 series
Good to know:
the hood has to be larger than the
cooktop(s) or it has to be as large as
the cooktop(s). Please check the
requirements in chapter ventilation.
Vario Teppan Yaki 400 series
V P 414
–
Cooking directly on the hard-
chromed metal surface, without any
pots or pans
–
Exact temperature control up to
240 °C
–
Optimum heat distribution
–
Solid stainless steel control knob
–
Precision crafted 3 mm stainless
steel
–
For surface mounting with a visible
edge or for flush mounting
–
Can be combined perfectly with
other Vario appliances of the
400 series
Cooking zones
Usable area W 31 x D 44 cm.
Handling
Control knobs with illuminated ring,
cooking zone and temperature
markings.
Electronic temperature control from
120 °C to 240 °C.
Features
Two zones, each 1500 W, can be
operated together as a complete
surface or each halve separately.
Keeping warm setting.
Cleaning stage.
Even with traces of use, always easy to
clean like a cast pan.
Safety
Safety shut-off.
Pre-heat and residual heat indicator.
Planning notes
Depending on the type of installation
(surface-mounted or flush-mounted,
with or without an appliance cover), the
specific location of the cut-out and the
knob positions may vary.
If combining several Vario appliances
of the 400 series, a connection strip
VA 420 must be placed between the
appliances. Depending on the type of
installation, the corresponding
connection strip must be provided.
The bearing capacity and stability, in
the case of thin worktops in particular,
must be supported using suitable
substructures. Take into account the
appliance weight and additional loads.
Additional instructions for flush mounting:
Installation is possible in worktops
made of stone, synthetics or solid wood.
Heat resistance and watertight sealing
of the cut edges must be observed.
Concerning other materials please
consult the worktop manufacturer.
The groove must be continuous and
even, so that uniform placing of the
appliance on the gasket is ensured.
Do not use discontinuous lining.
The joint width may vary due to size
tolerances of the combinations and of
the worktop cut-out.
Please read additional planning notes
on page 132 – 136.
If installing several appliances in
individual cut-outs allow for a division
bar of minimum 50 mm between the
individual cut-outs.
A minimum lateral clearance of at least
40 mm from adjacent heat-sensitive
furniture or contact surfaces must be
observed or thermal insulation fitted.
Appliance can be snapped into the
worktop from above.
Appliance weight: approx. 12 kg.
Connection
Total connected load 3.0 kW.
Connecting cable 1.5 m without plug.
