49
LED VERSION:
Class A/A+/A++
Luminaire supplied
with integrated LED modules
that cannot be replaced
A++
A+
A
67
Kamino
KAMINO
kg
5kN
50Nm
H2O STOP
.1 White
.6 Grey
.3 Anthracite
.18 Deep Brown
.4 Black
EU Regulation 874/2012 - Illumination equipment energy classes
LED VERSION:
Class A/A+/A++
Luminaire supplied
with integrated LED modules
that cannot be replaced
Recessed ground
fitting
Do not install in
hollow areas
Installation requires
a 30cm water drai-
nage layer (gravel)
Pre-wired with approx
250mm of cable
Static load: 2000Kg
walk over
Protection against
impact
IK 09- 10,00 joule
Drive over
Protection against
water ingress
from the cable
Glass surface temperature
<70°C
• Round luminaire with radial emission for installation in-
ground – recessed.
• Configuration: two sizes available. Die-cast aluminium
structure, EN AB-47100 alloy (low copper content).
Transparent borosilicate glass.
• Double layer coating for high resistance to corrosion: the
aluminium components are painted with a double coat
using powders which are compliant with QUALICOAT
standards: a first layer of epoxy powder (with excellent
chemical and mechanical resistance) and a second
finishing layer of polyester powder (resistant to UV rays
and atmospheric agents). The entire painting process of the
aluminium fitting starts from components which have been
sandblasted in advance to make the surface more porous
and increase the adherence of the paint. Ares effects
alkaline and acid washing to clean the surfaces completely,
then rinses with demineralised water to remove any residue
particles, subsequently a chemical conversion treatment is
done to protect against rusting.
• Light emission: one emission, two opposite emissions, four
emissions.
• Protection rating: IP67
• In compliance with EN60598-1 standards
• Class of insulation: II; version 24V: III
• Installation: the luminaire is equipped with a watertight
M12 screw-connector providing optimal insulation against
water ingress. 220-240V: the power supply unit is equipped
with a piece of cable of 400mm with screw connector
towards the luminaire and a piece of cable of 300mm to
be used for wiring. 24V: the luminaire is supplied with a
piece of cable with screw-connector to be used for wiring.
Outdoor use requires suitable flexible cables. Installation
requires a dedicated box to be ordered separately. It is
important to provide a >300mm gravel layer or a drain
system (for concrete surface) to ensure good drainage and
to avoid water stagnation. Kamino 24V is equipped with a
dc/dc highly efficient resin-coated converter that removes
electromagnetic interference and allows parallel wiring and
is protected against polarity reversal and sudden voltage
peak.
• We recommend the use of a connection system with a
protection degree greater than or equal to the protection
degree of the luminaire.
• During the installation and the maintenance of the fixtures
it is important to be careful and avoid damages on the paint
coating.
Damages on the coating exposed to outdoor conditions or
water, could cause corrosion.
Chemical substances affect the anticorrosion covering
protection.
.12 Forest Green