design
Klaus Begasse
2010
Cuneo
Light fixture with direct side emission,
with high-performance LED light sources.
Six monochromatic LEDs are used together with six
collimators and a light-diffusing prismatic screen to
obtain an optimum lighting beam.
Floor or wall installation. In the wall installation,
the light can be pointed either upwards
or downwards.
Available in two finishes:
light grey painted and rust painted.
Composed by lighting cap and terminal board
fixed together by means of locking screws.
Cap and terminal board in die-cast EN AB-47100
aluminium, gaskets in silicone rubber.
Electronic ballast integrated in the fixture.
PMMA collimators installed on the LED light sources.
Light-diffusing prismatic screen in PMMA
siliconed flush with the lighting cap.
Power connection to the mains to be carried out
outside the fixture, without need of opening it,
by means of a pre-installed IP65 connection device
suitable for cables with a diameter between
6 and 13 mm.
Wall installation by means of a bracket in folded
steel sheet to which the fixture is fastened
with two screws.
Screws in AISI 316 stainless steel.
All the components in die-cast aluminium
and the steel bracket for wall or floor fixing
are painted by means of 3-stage outdoor treatment:
nanotechnologies, antioxidant primer,
polyester paint.
Technical features of light fixtures in compliance
with EN60598-1.
IP Rating IP65.
ENEC approved.
Insulation class II.
180
