For further information on Ciclope
visit artemide.com
Ciclope
Alessandro Pedretti
(Studio Rota & Partners)
2009
Lighting system with diffuse unilateral or bilateral emission, with
high-performance LED light sources.
Light emission is obtained by the combination of six
monochromatic LED light sources, a reflector and an opaline
diffuser.
Floor in unilateral and bilateral emission, wall or recessed
installation.
Available in 3 finishes: light grey (RAL 9002), anthracite grey and
rust painted.
Technical features of light fixtures in compliance with EN60598-1.
ENEC approved.
Lighting unit consists of: frame in reinforced polymer; diffuser
in light-diffusing polycarbonate; plate in pickled, machined and
galvanised steel; watertight gasket in silicone rubber; LED circuit;
electronic ballast; reflector in painted spun aluminium; PG13.5
cable gland, H05RN-F cable and IP65 electrical connection
device suitable for cables with a diameter between 6 and 13 mm
to allow electrical interfacing with the external mains without the
need to open the fixture.
The lighting unit houses the electrical components
and sources.
Aesthetic cover in die-cast EN AB-47100 aluminium. The
components in die-cast, extruded aluminium and steel
are painted by means of 3-stage outdoor treatment:
nanotechnologies, antioxidant primer, polyester paint.
The elements are fixed together by means of screws. All the
locking screws used outside the fixture and inside the stem are
in AISI 304 stainless steel.
Ciclope floor: available in two heights (h 50cm and h 90cm),
stem in extruded EN AW-6060 aluminium. Ground mounting
plate in folded, welded and painted steel, with holes for ground
fixing by means of log bolts or dowels.
Ciclope recessed: recessing box in reinforced polymer, can be
ordered separately.
Ciclope wall: box in extruded EN AW-6060 aluminium.
754
755
