Molla
Ernesto Gismondi
2011
Light fixture with 2 combined light beams:
the large one with lighting function
and the narrow one with decorative function.
Wall installation. The fixture can be installed
with the main beam pointed either downwards
or upwards according to the kind of lighting desired
(direct or indirect).
The large beam is obtained by the combination
of a monochromatic LED light source with
a reflector. The narrow beam is obtained
by the combination of a monochromatic LED light
source with a high-performance projector.
Available in two finishes: light grey painted and
anthracite grey painted.
Composed by lighting cap unit and terminal
board fixed together by means of locking screws.
Cap and terminal board in die-cast
EN AB-47100 aluminium.
Watertight gasket in silicone rubber.
Electronic ballast integrated in the fixture.
Projector composed by a body in reinforced
polymer and PMMA lenses.
Tempered and silkscreened light-diffusing glasses,
siliconed flush with the lighting cap.
Power connection to the mains to be carried out
outside the fixture, without need of opening it,
by means of a pre-installed IP65 connection device
suitable for cables with a diameter between
6 and 13 mm.
Wall fixing by means of a bracket in folded steel
sheet to which the fixture is fastened
with two screws.
Locking screws used outside the fixture
in AISI 316 stainless steel.
Die-cast aluminium and bracket painted with 3-stage
outdoor treatment: nanotechnologies, antioxidant
primer, polyester paint.
Technical features of light fixtures in compliance
with EN60598-1.
IP Rating IP65.
ENEC approved.
Insulation class II.
778
